Coleman 5151C Specifikace stáhnout pdf (Strana 5)

GENERAL SPECIFICATIONS AND INSTRUCTIONS

DGAT & DGAM SeriesDLAS Series

60 1/2”

76”

19--1/2”

9--3/4”

23”

24”

10--5/8”

19--1/2”

9--3/4”

23”

24”

10--5/8”

15--- 7/8”

2”

1--- 7/8”

(on Sub--Base)

Figure 1 -- DLAS, DGAT, and DGAM Series Furnace Dimensions

IMPROPER INSTALLATION, ADJUSTMENT, SERVICE

OR MAINTENANCE CAN CAUSE INJUR Y OR PROPER-

TY DAMAGE.

PLEASE REFER TO ALL THE INSTRUCTIONS OF THIS

MANUAL FOR PROPER INSTALLATION PROCE-

DURES. IMPROPER INSTALLATION WILL VOID THE

W ARRANTY.

THE FURNACE SHALL BE INSTALLED SO THE ELEC-

TRICAL COMPONENTS ARE PROTECTED FROM

WA TER.

DO NOT TEST THE FUEL SYSTEM AT MORE THAN 14

INCHES WATER COLUMN AFTER FURNACE HAS

BEEN CONNECTED TO THE FUEL LINE. SUCH TEST-

ING MAY VOID THE WARRANTY. ANY TEST RUN

ABOVE 14 INCHES WATER COLUMN MAY DAMAGE

THE FURNACE CONTROL VALVE WHICH COULD

CAUSE AN EXPLOSION, FIRE, OR ASPHYXIATION.

These instructions are intended for the use of qualified indi-

viduals specially trained and experienced in installation of

this type of equipment and related system components.

Installation and service personnel are required by some

states to be licensed.

Persons not qualified shall not install this equipment or

interpret these instructions

NOTE

The words “Shall” or “Must” indicate a requirement which is

essential to satisfactory and safe product performance.

The words “Should” or “May” indicate a recommendation or

advice which is not essential and not required but which may

be useful or helpful.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Coleman 5151C Specifikace Strana 5

Komentáře k této Příručce

Související produkty a manuály pro ne Coleman 5151C