Coleman F5BMS-C Servisní příručka stáhnout pdf (Strana 25)

Lower unit leakage check

Connecting the leakage tester to the oil level checking hole to check the lower unit leakage. If the

pressure drops (pressure: 1kg/cm³), inspect the oil seal and components.

GENERAL INSPECTION

Anode

Inspect lower unit anode and engine anode (on the thermostat cover). Clean the greasy dirt and

scales. If wear or damage is above 1/2, replace the anode.

CAUTION:

Cannot grease or paint the anode, or it will not operate properly.

Grease points

1. Refer the illustration for greasing points, paint the water resistant grease.

2. Paint anti-corrosion grease on the propeller shaft.

Cooling water passage

1. Inspect cooling water passage

If blocked, clean it.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 92 93

Žádné komentáře

Coleman F5BMS-C Servisní příručka Strana 25