Coleman F5BMS-C Servisní příručka stáhnout pdf (Strana 22)

2. Remove cylinder head cover

3. Use feeler gauge to measure the clearance between rocker arm and valve rod top: if out of

specification, adjust.

Valve clearance (cold position):

Inlet valve: 0.10±0.02mm

Outlet valve: 0.10±0.02mm

Spark plug

1. Remove spark plug cap and spark plug.

2. Clean off carbon build-up on the electrodes.

3. Check if the electrodes are corroded or have deposit, or if the washer is damaged.

If necessary, change the spark plug.

Spark plug type: BPR7HS

4. Inspect if the spark plug gap is within specification. If necessary, change the spark plug.

0.6-0.7mm

5. Install spark plug. Use spark plug spanner to tighten it according to specified torque.

Specified torque: 25 Nm

CONTROL SYSTEM

Throttle grip

1. Turn the throttle grip to fully closed position.

2. Check if the throttle cable is slack and if the throttle lever touches the throttle stop screw.

3. Loosen throttle cable stopper screw, adjust throttle cable position, and tighten throttle cable stop

screw.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 92 93

Žádné komentáře

Coleman F5BMS-C Servisní příručka Strana 22